If you appreciate the work done within the wiki, please consider supporting The Cutting Room Floor on Patreon. Thanks for all your support!

Bugs:Nintendo Labo Toy-Con 04: VR Kit

From The Cutting Room Floor
Jump to navigation Jump to search

This page details bugs of Nintendo Labo Toy-Con 04: VR Kit.

Teleporting Extending Objects Growth

There is a bug in the Toy-Con Garage VR Plaza's engine that allows Extending Objects to grow in size beyond the game's normal limits.

Call up an Extending Object, then place a Teleport Entrance right inside the Extending Object, then take a Teleport Exit and rotate it (-120 or 120 degrees are a good spot) either in the Horizontal or Vertical Angle and make sure the teleport physics are set to Reset. When the Extending Object is being teleported multiple times to a rotated exit, the Extending Object will drastically grow in size (even though there are no inputs being used in the Node) and will allow scaling beyond 10 meters (which is the max size for Object Nodes) and Touch Sensor Node will not be affected in its glitched size. If the Teleport Exit is rotated in both axes (e.g. Horizontal=-120, Vertical=120) rather than one, the shape of the box will also be distorted and can shape like a parallelogram. If it is grown too much, the Extending Object will get deleted. The Extending Object will go back to normal size if grabbed using a Hand Node.

This is best used with an On Start and a Timer Node set to output after 0 seconds and for 0.4 seconds long: connect the On Start to the Timer, then the Timer to its Teleport Entrance. This trick is useful for easily creating a water surface instead of just repeating Box Objects.

(Source: Devan Wolf on Twitter)